A little cold. A lot of freedom.CONTAINS AFFILIATE LINKS · THE NETHERLANDS
WinterFietsPleinWINTER CYCLING ESSENTIALS
EN/NL/BE/DE
GRIP & TRACTION

Bike Tyre Pressure in Winter: How Much Air Should You Use?

Updated · 6 min read · How we research

Affiliate links: this guide links to retailers. If you buy through one of these links, we may earn a small commission at no extra cost to you. It never changes what we recommend.

Want a gauge that reads accurately? See the quick pick below.

Quick picks

Chosen from manufacturer specs and published sources. We haven't tested these ourselves. How we choose →

  1. Good for Checking pressure accurately on any valve type

    Schwalbe AIRMAX PRO

    Schwalbe lists it as a digital pressure gauge for up to 11 bar, compatible with all valve types; a classic Dutch (DV) valve needs the Schwalbe valve insert.

    See prices at bol.com

Before you order: check that the gauge fits your valve type (Dutch/Dunlop, Presta or Schrader) before you buy.

Links open the retailer's search results in a new tab. Most Dutch shops are in Dutch, so we fill in the search for you.

A common cause of sluggish rides and flats in winter is a tyre that is softer than the rider thinks (our reasoning). Some readers call them tires; the advice is the same. Pressing the tread with a thumb does not tell you much, and cold mornings make it worse. This page covers pressure, pumps and gauges. If you are still choosing a tyre, start with our winter tyre guide.

What pressure should my bike tyres have?

Read the sidewall. Every bike tyre carries a minimum and a maximum pressure, and Schwalbe says never to go outside that range. Schwalbe also states that it gives no general recommendation for a specific bike or tyre, because the right value inside the range depends mainly on the load the tyre carries.

For orientation, ANWB describes a soft tyre as roughly 1 bar and hard-inflated bike tyres as 2 up to 8 bar, with thin racing tyres at the top and comfort-oriented mountain bike tyres lower. Pressure is measured in bar in the Netherlands, so your pump gauge and the sidewall will normally match. ANWB also points to Schwalbe's pressure table, which is organized by rider weight and tyre width up to 60 mm, if you want a starting value for a specific tyre.

How do weight and tyre width change the number?

Heavier loads and narrower tyres need more air, and wider tyres can run softer. Schwalbe says the load is mostly rider weight plus luggage, and that very small wheels also need more pressure. Higher pressure lowers rolling resistance, wear and sensitivity to flats, while lower pressure gives comfort and grip.

Continental gives one concrete reference in its tyre manual (the 2018 edition): for a city or touring rider of about 80 kg, ride the tyre at about 80 % of the printed maximum. The same manual says that with heavy loads such as luggage or a child seat, and when the permissible total weight is reached, the tyre should always be ridden at the maximum permitted pressure.

Situation Direction to move inside the sidewall range Source
Light rider, no luggage Lower half Our reading of Schwalbe: load decides the pressure
About 80 kg on a city or touring bike About 80 % of the printed maximum Continental manual (2018)
Child seat or loaded panniers Toward the maximum Continental manual (2018)
Wider tyre Can run softer Schwalbe
Narrow tyre Needs more Schwalbe

E-bikes and cargo bikes are heavier than they look, and the weight of the bike counts toward the load on the tyre. Schwalbe and Continental give no separate e-bike figure in the sources listed here, so our rule of thumb is: start from the middle of the sidewall range, and move toward the maximum when you carry children or groceries. Our e-bike winter guide covers the battery side.

Should you run lower tyre pressure in winter?

A little lower can help, within the sidewall range. ANWB says that for extra grip on snow or ice you can pump a normal tyre slightly less hard. Schwalbe's winter tips say the same in short (less air, more grip) and add that you must not go below the minimum printed on the tyre.

The limit matters. ANWB lists faster wear, sidewall cracks and pinch flats as the cost of soft tyres, and Continental's manual warns that with too little pressure the inner tube may be squashed. Cold also works against you: Continental explains that cold makes the air inside a tyre contract, so a tyre that was fine in September can be under-pressured on the first frosty morning. Schwalbe adds that studded tyres give their best spike grip near the minimum, while a higher pressure reduces noise on dry asphalt. See riding on ice and snow for the technique side.

How often should you check tyre pressure?

Schwalbe says at least once a month, because even tight inner tubes lose air and a loss of about 1 bar per month is considered normal. If you use latex tubes, Schwalbe says to check before every ride. Continental's manual tells riders to check before every ride with a pump that has a gauge.

For a daily commuter, a monthly check is the floor. A quick gauge reading after the first cold nights, and again before a long or loaded ride, costs thirty seconds. The thumb test fails for a reason ANWB gives: anti-puncture tyres feel harder than they are, and from about 2 bar many tyres already feel firm. Squeezing the sidewall is a little better than pressing the tread, but a gauge settles it.

How do you set the right pressure? A five-step routine

  1. Read the minimum and maximum on the sidewall and write them on a sticker inside your pump bag or on the frame.
  2. Pick a starting value: about 80 % of the maximum if you weigh around 80 kg on a city bike (Continental), lower if you are lighter, higher if you carry a child or luggage.
  3. Inflate and measure with a gauge, not with your thumb.
  4. Ride a few days. If the bike feels harsh and skittish on wet tiles, drop a little. If it feels sluggish or the rim hits through potholes, add a little.
  5. Re-measure after the first frost and then monthly.

Which pump and valve do you need?

Check your valve first, because it decides the pump. ANWB describes four types: the Dutch (Dunlop) valve common on city bikes, the thin French (Presta) valve on sporty bikes, the Schrader (car) valve, and Schwalbe's Click valve, which needs a pump with a gauge.

Valve Where you see it Notes from ANWB
Dutch / Dunlop Most city bikes No unscrewing; a classic floor pump clamp fits
French / Presta Sporty bikes Long and thin, fragile; unscrew the top first
Schrader / car Some mountain bikes, scooters Can be used at a gas station air hose
Click valve Some Schwalbe tyres and tubes Click the pump head on; needs a gauge

ANWB points out that a classic floor pump with a red hose has no gauge, and that adapter nipples let one pump serve every valve. For winter, a floor pump with a built-in gauge covers most needs. If you want a separate reading, a floor pump with a gauge is the simplest upgrade. Mini pumps are fine for roadside repairs, though ANWB notes they move little air per stroke.

A gauge worth a look

Schwalbe lists the AIRMAX PRO as a digital gauge for pressures up to 11 bar that works with all valve types. A classic Dutch valve needs the Schwalbe valve insert, so check that before ordering. A gauge is the reliable way to match the range printed on the sidewall. We have not used it, and this is based on the maker's specification page.

A flat in the dark is one cost of a soft tyre, so keep the winter bike problems guide handy. Tyre pressure is one line in the monthly routine of the winterize checklist.

Frequently asked questions

How many bar should my bike tyres be?

There is no single number. The allowed range is printed on the sidewall, and the right value inside it depends mostly on your weight plus luggage, according to Schwalbe. ANWB notes that hard-inflated bike tyres run from 2 up to 8 bar, so read your own tyre rather than copying someone else's figure.

Should you lower bike tyre pressure in winter?

Slightly, if you want more grip on snow or ice. ANWB suggests pumping a bit less hard, and Schwalbe says less air gives more grip. Never go below the minimum on the sidewall, because a tyre that is too soft wears faster and can be squashed against the rim.

How often should you check bike tyre pressure?

Schwalbe says at least once a month, since even good inner tubes lose roughly 1 bar per month. With latex tubes, check before every ride. Continental's tyre manual advises checking before every ride with a pump that has a gauge, which is a good habit when you ride daily in the dark.

Does cold weather lower bike tyre pressure?

Yes. Continental explains that cold makes the air in a tyre contract, so a tyre that was correctly inflated can be under-pressured on a cold morning. It gives no figure for bikes, so the practical answer is to measure with a gauge after a cold night and top up to your chosen value.

What is the difference between Dunlop, Presta and Schrader valves?

ANWB describes the Dutch (Dunlop) valve as the common city-bike type that needs no unscrewing, the thin French (Presta) valve as usual on sporty bikes with a top that must be unscrewed, and the Schrader (car) valve as the type found on some mountain bikes. Adapter nipples let one pump fit all three.

Sources

  1. ANWB: Fietsband oppompen
  2. ANWB: Fietsband vervangen en kopen
  3. Schwalbe: Luchtdruk (techniek-FAQ)
  4. Schwalbe: Veilig de winter door (wintertips)
  5. Continental: Mounting and care instructions for clincher and folding tyres (2018)
  6. Continental: Highest quality for bicycles
BEFORE YOU UNLOCK THE BIKE

Six quick checks for your lights, tyres, brakes and you. Tick them off on your phone at the door.

Open the checklist
NEWSLETTER

Get winter-ready by email

Three short emails to get you winter-ready, then a note now and then while the cold lasts. Unsubscribe anytime.

We send the newsletter with MailerLite. See our privacy policy.